Who Is Jack In The Term Jack-o-lantern?
Then, scrape the inside of the pumpkin with your spoon to remove any soft tissue and prevent rotting. Now, cut out your design with the knife using an up and down motion along each line you drew. Finally, set a candle or light inside of your carved pumpkin and put the top back on.
You won’t have a lid to fall in as the pumpkin softens. Be sure to consider the ugly, asymmetrical pumpkins, as you can often use their shape as part of your design. Read on to learn more about how to carve a pumpkin and why we carve them in the first place. Pumpkins are not gourds, even though pumpkins and gourds are both used for fall decorating.
You can use a serrated knife from your kitchen or the largest serrated tool in a pumpkin carving kit. Draw a circle with about a 2 in (5.1 cm) radius from the stem with a washable marker. Tilt the blade at a 45-degree angle toward the stem and push it into the pumpkin.
Start by washing the seeds thoroughly; then, grind them in a food processor until they are smooth. That’s right, early jack-o-lanterns were carved from root vegetables. Unbeknownst to the ancient Celts, their fall tradition of Samhain and of keeping evil spirits at bay would evolve throughout the centuries. Samhain morphed into Halloween, and the myth of Stingy Jack and the use of jack-o’-lanterns to scare off his evil spirit arose. But unlike the spooky-yet-cute jack-o’-lanterns we’re familiar with today, the earliest jack-o’-lanterns appeared quite macabre. With crudely-cut eyes and mouths, their faces seemed fully capable of truly frightening both the living and the dead.
Once you have finished carving, spray or wipe the inside of the cavity, and all the cut surfaces, with an essential-oil-based cleaning spray. Or soak the finished pumpkin overnight Kids in a tub of borax water. Use long fireplace matches or a lighter with a long neck to help protect your fingers and hands while lighting a candle inside a jack-o’-lantern. If you cut your initial opening in the bottom, this isn’t an issue as you just light the candle out in the open and then lower the jack-o’-lantern over it. Once you’ve made a cut you can’t erase it, so it’s a good idea to sketch your design onto the surface of the pumpkin before picking up a cutting tool. A felt tip marker works well for sketching and drawing.